jpmc86 Posted October 13, 2014 Share Posted October 13, 2014 I wanted to apply gloss coat over 2.0 however, I wanted to make sure that I do not abrade the surface anymore than is needed as the clear coat on this car appears to be weak. What would be the best possible way of applying gloss coat and making sure that it will stick to the coat/paint? Not much information on gloss coat, would have expected which such a drastic change from 2.0 to gloss coat that optimum would have made as much information available. But that is just a whole other subject. Cheers! Link to comment Share on other sites More sharing options...
moorfan Posted December 5, 2014 Share Posted December 5, 2014 Chris, I am doing what you advised re: using HyperPolish on a finishing pad to "scuff up" a three year old OptiCoat 2.0 application prior to applying Gloss Coat. Is there any issue with then following up with a true "jeweling" step with Finish Polish prior to Gloss Coat? Or do you think Finish Polish would be enough to prepare the OC2.0 surface to accept Gloss Coat and skip the HyperPolish altogether? Thanks, Pete Link to comment Share on other sites More sharing options...
Setec Astronomy Posted December 6, 2014 Share Posted December 6, 2014 It may be a while before you hear from Chris, IMO you're fine just using the Finish and then going to Gloss-Coat. Link to comment Share on other sites More sharing options...
Lowejackson Posted December 16, 2014 Share Posted December 16, 2014 It may be a while before you hear from Chris...... Is he focusing on his own site or up to something new? Link to comment Share on other sites More sharing options...
Setec Astronomy Posted December 16, 2014 Share Posted December 16, 2014 I don't know, I just know he doesn't come on here very often. I only mentioned that because the question was directed at Chris but I decided to answer it so the poster wouldn't have to wait an undetermined amount of time for an answer. Link to comment Share on other sites More sharing options...
moorfan Posted December 17, 2014 Share Posted December 17, 2014 Thank you for your response Setec! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.