I really like Poliseal on a white LC pad applied with a PC and the Optimum Polish with a green or blue Edge pad on the rotary. The problem is getting the pads clean afterwards. Lately I've just been soaking them overnight in warm water after spraying and scrubing with a simple green type cleaner. I'm open for suggestions that will clean better and faster but will not hurt my pads.
0
Cleaning foam pads
Started by Junebug, Jul 11 2007 09:15 AM
5 replies to this topic
#2
-
- Members
-
- 35 posts
Optimum Apprentice
- Location:San Antonio, TX
Posted 11 July 2007 - 03:54 PM
Spray them with degreaser, then pressure wash them. The PW will not hurt the pads, and if you shake them out, then run them on a rotary for a minute or two, they will be ready to use again immediately.
#3
-
- Members
-
- 260 posts
Optimum Fanatic
- Gender:Male
- Location:Florida
Posted 11 July 2007 - 05:57 PM
I've had no problem with Dawn dish washing liquid.
You can't have manslaughter without laughter.
#4
-
- Members
- 8 posts
New to the Forum
Posted 12 July 2007 - 11:18 AM
Yeah, I found an old tooth brush and Dawn works ok. I just wondered if there was something out there I was missing.
#5
-
- Members
- 1 posts
New to the Forum
Posted 22 April 2008 - 11:31 PM
Junebug, on Jul 12 2007, 09:18 AM, said:
Yeah, I found an old tooth brush and Dawn works ok. I just wondered if there was something out there I was missing.
I don't scrub any of the pads I just wash them with SA8 From Amway, Works GREAT in both cold and hot H2O
#6
-
- Members
-
- 115 posts
Optimum Obsessed
- Gender:Male
- Location:Quebec Canada
- Interests:dirt track racing, family and friends
Posted 27 May 2008 - 10:12 PM
To effectivly clean pads we use a LC System 2000 pad cleaner, the most expensive bucket I have ever purchaced, and the most cost effective as well.
At Your Service
Yvan
www.chipdoctors.com
Yvan
www.chipdoctors.com
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users
