fellipe

To presoak or not presoak? ONRww

Recommended Posts

For my production express mobile car wash business, the least time spent on a car the better.

 

I've been trying to understand WHY should I presoak the car prior to the rinseless wash. I'm not yet convinced that it's necessary. Can you help me?

Share this post


Link to post
Share on other sites

As far as I know the official instructions do not say you should prespray the paint. However, I would suggest giving ONR a minute or two to dwell on the dirt will help loosen it. I can spray my entire car in less than two minutes so I would suggest the extra time is not significant. Maybe another way at looking at this issue is to say at the very least it will not cause any harm

 

If you wish to not prespray the cars then ONR will obviously still work well

Share this post


Link to post
Share on other sites

Some guys will set up ONR in a insecticide type pump sprayer. Spray down an area, say roof and hood. They will then begin the No Rinse as suaul on the roof, this gives the ONR solution time to dwell on the hood, which is where most of the grime is from bugs and such. Then No Rinse the hood as usual.

 

Move on around the car until done.

 

No Rinse is designed to break down and emulsify grime so some cars will be clean and ready for drying after one pass of your mitt. Other will need 2 or 3 passes. The test is to look at your drying towel. It should be pretty much free from dirt after drying a panel.

 

Anthony

Share this post


Link to post
Share on other sites

I thinks wiping on a wet surface would be easier on the paint. Any chance of getting the dirt loose and even encapsulated in droplets would make your job look better. Some times what someone thinks is a waste of time is not always what others do. I would just because it may help me in the long run.

Share this post


Link to post
Share on other sites

I’ve always presoaked but as I am getting older it’s getting tiring lol

If ONR was designed to be used without presoak then I suppose it’s safe without it?  Still using your best judgement depending on your case. 

Share this post


Link to post
Share on other sites

Once and a will I like to pre soak  the car with onr I use my pro 12 ik sprayer this thing can be filled with air from a compressor so you have alot of pressure and can get the onr in the gaps around doors and panels and flush out dirt  then I flood car with big red sponge and wipe clean  it also has a long handle you can do the roof of a suv standing in one spot its very fast to cover any car with all optimum products 

Share this post


Link to post
Share on other sites

I think it's a case by case situation.  I always pre=spray (as opposed to pre-soak), hitting the bugs on front, wheels, tires, wheel wells, and rear before doing rinseless wash.  Sometimes it's not necessary, but is a habit for me.

Share this post


Link to post
Share on other sites

Yes I am the same now since i have completely gone to the dark side   lol  a quick spray down the dirty areas  only takes a minute.  Cant see any mobile detailer not doing this .

Share this post


Link to post
Share on other sites
9 hours ago, Ron@Optimum said:

I think it's a case by case situation.  I always pre=spray (as opposed to pre-soak), hitting the bugs on front, wheels, tires, wheel wells, and rear before doing rinseless wash.  Sometimes it's not necessary, but is a habit for me.

I meant prespray by presoak.  I use a portable washer which I fill with ONR and rinse the entire car down before using the BRS and bucket.

https://www.snowjoe.com/products/sun-joe-wa24c-lte-24v-150-psi-max-multi-purpose-clean-anywhere-portable-spray-washer-with-5-gal-tank

I do this during the winter time when my landlord shuts off the outdoor water supply to prevent the pipes from freezing.

But since I have completely moved away from traditional washes just wanted to know if I can skip the prespray/presoak/pre-rinse step.

Share this post


Link to post
Share on other sites

my cars never get that dirty so i’ve played around with pre soaking vs pre rinsing vs nothing and the results are roughly the same 

in the end, ive stuck with pre rinsing with a hose just because it’s the quickest method and knocks off the most annoying debris (live bugs,  residual leaves, etc)

my routine before i start a wash is to rinse the car off, foam power clean (1:3) from an ik foamer to the lower part of the car and in particular the wheels and exhaust, rinse off and then bring the car in for an indoors rinseless wash 

Share this post


Link to post
Share on other sites

I always rinse the car  with hose before  i do any thing .  Onr is not waterless wash as far as I know my car  is gloss coated and optimum wax and opti seal 80 % of the dirt comes of with the hose then soak car with onr with ik or weed sprayer then onr wash .  I also  like to use foam on the realy dirty parts as well. Coming back from fishing once the car was realy a mess   I  rinsed the car sprayed the hole car with onr and then put optimum soap on  top with foam cannon and   then washed  with several mitts soaked in onr  it kills the foam a  bit but wow its  very  slippery  soulution . 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now